Our Products
The InnoDisk SATA 3MG-2P is a MLC Flashdrive with SATA II Interface which convinces through the random I/O performance from 70K (read) and 25K IOPS (write). But also the streaming performance achieves top values from 520 respectively 450MB/s.
This serie meets the requirements of I/O intensive enterprise and data base applications as well as demanding applications in a rough environmental of industry and production.
The SATA 3MG2-P is based on the Evergreen L2 achitecture which guarantees a long endurance thanks to the full developed Wear Leveling Technics.
The InnoDisk SATA 3MG-2P with 2.5" format is available with capacities from 8GB up to 1TB (with MLC Flash Technology).

The SATA 3MG2-P can also be delivered as SATA Slim and M.2 (NGFF) Form factor
InnoDisk SATA 3MG-2P Flash Storage Drive
  • 8, 16, 32, 64, 256, 512GB, 1TB Synchronous MLC NAND Flash memory
  • High I/O and Streaming performance
  • No moving parts
  • Standard SATA III Interface
  • Standard Harddisk format
  • Evergreen L2 Architectur
  • ECC Defect Management
  • Wear Leveling
  • TRIM
  • Low Write Amplification (WAI)
  • Improved powermanagement
  • S.M.A.R.T Monitoring
  • Shock and vibration resistant
  • Low power consumption
    DEVSLP Support
  • No additional driver software required
  • Extended temperature range optional
Specification
Form Factor/Maße 2,5"
Width 69,85 mm
Depth: 100 mm
Hight: 7mm
Solid State MLC NAND Flash (Industrial standard) no moving parts
Interface SATA III 6.0G
Mounting Harddisk Industrial standard, all orientation
Connector Standard 7-pin Signal Segment and 15-pin Power Segment
Transfer Modes SATA I, SATA II and SATA III support
Data transfer modes up to 520MB/s Sustained Read and .450MB/s Sustained Write (depending on capacity)
I/O Performance up to 70000 IOPS Random Read and 25000 IOPS Random Write (depending on capacity)
Software No driver software required
Sectors Standard 512 Byte Sectors
Additional features Temperature sensor
Conformal Coating (optional)
iCell protection against voltage dips (optional)
Flash Management ECC,
Static Wear Leveling,
Bad Block Management
S.M.A.R.T. Monitoring
TRIM
Power Cycling Management
iDataGuard
DRAM Puffer (optional)
Voltage 5VCC +/- 5%
Power consumption 3mW (DEVSLP) up to max. 6W (Write)
Capacity 8, 16, 32, 64, 128, 256, 512GB, 1TB
Temperature range (operating) 0°C bis 70°C Standard Temperature range
-40°C bis +85°C Industrial Temperature range
MTBF >3 000 000 hours (Telcordia 25°C)
Durability (TBW) 3,89TB (8GB) up to 498,7TB (1TB) written data (sequential)
Warranty 6 years
Order information
On request

Please ask for additional products
(Technical details are subject to change without prior notice)